Yaesu FT-897 Technical Supplement page 17

Battery Indicator Alignment
Connect a DC power supply to pin 4 of JP4007, and
connect pin 6 to the ground lead from the power sup-
ply.
Adjust the power supply voltage exactly to 11.0 V.
Adjust VR4001 until you see an orange blink on the
BATT-A indicator.
VR4001 JP4007
Software Menu Alignment
The antenna connector should be connected to a dummy
load (in cases where transmission is involved) or the signal
generator (in the case of reception). General alignment con-
ditions are as follows unless otherwise noted.
AF-gain knob:
RF-gain knob:
SQL:
ATT/IPO/CTCSS/DCS:
Output power:
AGC:
Break-in:
CW Keyer:
VOX:
Press and hold in the Multi Function Keys [A], [B],
[C] simultaneously and turn on the transceiver while hold-
ing them in; the alignment menu will then be activated (you
will hear a "diddle-diddle-diddle" opening tone sequence
to confirm that the alignment menu has been activated).
In the alignment procedures, each alignment parameter
is selected by rotating the MAIN dial. Each Alignment item
is selected by rotating the MEM/VFO CH knob.
To store the alignment parameters when you are satis-
fied with the adjustment, press the [MENU] key for longer
than a half second.
Alignment
Center
Fully clockwise
Fully counterclockwise
Off
High
Auto
On
Off
Off
17