Front Crossmember Support Plate - Subaru Legacy 2004 Service Manual

3. Front Crossmember Support
Plate
A: REMOVAL
1) Lift-up the vehicle.
2) Remove the front under cover. <Ref. to EI-26,
REMOVAL, Front Under Cover.>
3) Remove the bolt and remove front crossmember
support plate.
• Large type
• Small type
(1)
(1) Crossmember support plate
(2) Jack-up plate
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Tighten the small type crossmember support plate
together with stabilizer bracket.
After installing the stabilizer bracket to crossmem-
ber, tighten the crossmember support plate togeth-
er.
Tightening torque:
Crossmember support plate:
'
60 N m (6.1 kgf-m, 44.3 ft-lb)
Crossmember support plate (Joint tightening
portion of stabilizer bracket):
'
25 N m (2.5 kgf-m, 18.1 ft-lb)
Jack-up plate:
'
60 N m (6.1 kgf-m, 44.3 ft-lb)

Front Crossmember Support Plate

FS-00104
(1)
(2)
FS-00105
FS-15
FRONT SUSPENSION