BODY PANEL REPAIR PROCEDURE - Door
3.
Bend the flange hem with a hammer and dolly, then fasten tightly
with a hemming tool.
NOTE
1.
Hemming work should be done In three steps as illus-
tration.
2.
If a hemming tool cannot be used, hem with a hammer
and dolly.
4.
After completing the hemming work, make MIG spot welds at 50
mm intervals on the inside.
5.
Clean and prepare all welds, remove all residue.
6.
Apply the two-part epoxy primer to the interior of the door panel.
111