Daewoo Espero Owner's Manual page 68

PROCEDURES
Pry the wheel cover off with the wheel
•
nut wrench.
• Loosen the wheel bolt one turn each
with the wheel nut wrench, but do not
remove any bolt until the wheel has
been raised off the ground.
"--
\ '
• Turn the jack screw clockwise four
turns and place the jack at the front
or rear jacking location closest to the
wheel you are changing. Place the
jack under the jacking point at the
side sill as shown in illustration.
• Raise the vehicle by turning
crank handle clockwise until the jack
lifting head fits firmly into the notch and
the wheel is off the ground (about
3cm).
Do not raise the vehicle more than ne-
cessary.
7-3
• Remove the wheel bolts by turning
them anticlockwise and then remove
the wheel.
• Mount the spare wheel in position and
tighten the wheel bolts hand-tight by
turning clockwise.
• Turn the jack handle anticlockwise
and lower the vehicle to the ground.
Tighten the wheel bolts firmly in "X"
pattern (1-2-3-4).
the
• Replace the wheel cover.
I I I
NOTE
• To eliminate the possibility of the
jack, jack handle and tools rattling
while the car is moving, stow them
properly.
• When cleaning the plastic wheel
covers, wash with plenty of water
and use a sponge, chamois or soft
cloth to prevent scratching or dam-
aging the finished surface.
I