Miele H 4700 B Operating And Installation Instructions page 53

Remove any residual cleaning
agents with clean water as these will
also hinder the anti-stick effect.
Normal soiling
Clean as soon as possible after each
use with a dishcloth, soft sponge or a
soft nylon brush, and a solution of hot
water and a little washing-up liquid.
If necessary, the reverse of a non-
scratching washing-up sponge can be
used.
Cleaning is made easier if soiling is first
dampened with a solution of washing-
up liquid.
Stubborn soiling
Remove the catalytic back panel
before using oven spray. The
chemicals used in oven sprays will
damage catalytic enamel, rendering
it ineffective.
Allow the PerfectClean surfaces to cool
down to room temperature before
cleaning. Apply a proprietary oven
cleaning spray (such as the Original
Miele oven cleaner) and leave to take
effect for approx. ten minutes.
When using the Original Miele oven
cleaner, the time stated on the
packaging can be slightly extended if
needed.
If necessary, the scouring pad on the
back of a non-scratching washing-up
sponge or a soft nylon brush can be
used to loosen the soiling.
Repeat the process if necessary.
After cleaning, rinse thoroughly with
clean water and then dry thoroughly.
Cleaning and care
Stubborn soiling, e.g. from roasting,
may need to be soaked first with a
damp sponge to loosen it and, if
necessary, a non-abrasive stainless
steel spiral pad or a scraper suitable for
glass can be used to remove it.
These cleaning tips will help to ensure
that the surface is cleaned thoroughly.
Should the PerfectClean surface be
damaged by any of the above
measures not being heeded, it will still
retain the anti-stick qualities of standard
enamel and be as easy to keep clean
as standard enamel.
Note:
– Soiling such as spilt juices and cake
mixtures is best removed whilst the
oven or tray is still warm. Exercise
caution, make sure the oven is not
too hot - danger of burning.
– Spilt fruit juices or roasting residues
may cause lasting discolouration to
the surfaces and can cause matt
areas to appear.
This discolouration is permanent but
will not affect the efficiency of the
enamel. Clean these following the
instructions given above and do not
use force to remove them.
53