Removing The Gas Regulator - KitchenAid JOB AID 4317282 Technical Education

REMOVING THE GAS REGULATOR

WARNING
ELECTRICAL SHOCK HAZARD
Disconnect power before servicing the range.
Replace all panels before operating range.
Failure to do so can result in death or electri-
cal shock.
FIRE HAZARD
Shut off gas supply line valve before servic-
ing the range.
Check all gas line connections and replace
all panels before operating the range.
Failure to do so could result in explosion, fire,
or other injury.
CAUTION: When you work on the dual fuel
range, be careful when handling the sheet
metal parts. Sharp edges may be present, and
you can cut yourself if you are not careful.
1. Turn off the gas and electrical power going
to the range.
2. Remove the oven door from the range
(see page 2-25).
3. Remove the two outer screws from the top
trim strip and remove the strip.
Outer Screw Top Trim Strip
4. Remove the two screws from the center
trim strip and remove the strip.
Screw Center Trim Strip
5.
Screw
6.
7.
Outer Screw
8.
Screw
2-16
Remove the two screws from the bottom
trim strip. Lower the trim strip so it is free
of the slots in the sides of the oven, and
remove the strip.
Bottom Trim Strip
Remove the inlet and outlet gas lines from
the gas regulator.
Remove the two screws from the gas
regulator mounting bracket and remove
the gas regulator assembly from the range.
Mounting
Bracket
Bracket
Screw
Gas
Outlet Line
Gas Regulator
Remove the two screws holding the gas
regulator to the mounting bracket and
remove the regulator.
Screw
Bracket
Screw
Gas
Inlet Line