Table of Contents
Advertisement
Onset installation
Preparing the worktop
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Safety
distances").
Wooden worktops
Seal any cut surfaces on the wood
worktops with a special varnish,
silicone rubber, or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be heat-
resistant.
Make sure that the sealant does not
come into contact with the top of the
worktop.
The seal under the appliance ensures
that the hob will sit securely in the cut-
out without slipping. Any gap between
the appliance frame and worktop will
become smaller over time.
Secure the spring clamps
The exact positioning of the spring
clamps is shown in the individual hob
diagrams.
Wooden worktops
Position the spring clamps on the
top edge of the cut-out as shown in
the hob illustration.
Fasten the spring clamps using the
3.5 x 25 mm wood screws supplied
with the appliance.
Installation
61
Hide quick links:
Advertisement
Table of Contents
