Tesla S Owner's Manual page 191

Instructions for Transporters
Disable the Self-Leveling Air
Suspension System
If Model S is equipped with the air suspension
system, it automatically self-levels, even when
power is off. To prevent damage, you must
activate Jack Mode to disable self-leveling:
1. Touch Controls > Suspension on the
touchscreen.
2. Press the brake pedal, then touch Very
High to maximize height.
3. Touch Jack.
When Jack Mode is active, Model S
displays this red indicator light on
the instrument panel, along with a
message telling you that active
suspension is disabled.
Note: Jack Mode cancels when driving speed
exceeds 4 mph (7 kph).
Warning: Failure to activate Jack Mode on
a vehicle equipped with the air
suspension system can result in the
vehicle becoming loose during transport,
which may cause significant damage.
Activate Transport Mode
Transport Mode keeps the parking brake
disengaged while winching Model S onto a
flatbed truck. When active, Transport Mode
displays a message indicating that the vehicle
will remain free-rolling. The following are
required to enable Transport Mode:
• 12V power is required. You are unable to
use the touchscreen to activate Transport
Mode if Model S has no power.
• Model S must detect a key. Transport
Mode is available only when a key is
detected.
To activate Transport Mode:
1. Ensure the vehicle is in Park.
2. Chock the tires or otherwise ensure
Model S is secure.
3. Press and hold the brake pedal, then on
the touchscreen, touch Controls >
Service > Towing. The touchscreen
displays a message reminding you how to
properly transport Model S.
4. Press and hold the Transport Mode button
until it turns blue. Model S is now free-
rolling and can slowly be rolled (no faster
than walking speed) or winched.
190
To cancel Transport Mode, shift Model S into
Park.
Caution: If the electrical system is not
working, and you therefore cannot use
the touchscreen to activate Transport
Mode, use self-loading dollies or tire
skates. Before doing so, always check the
manufacturer's specifications and
recommended loading capacity.
Pull onto the Flatbed Truck - With
Tow Eye
1. Locate the tow eye.
2. Remove the tow eye cover by inserting a
small flat screwdriver into the slot located
along the top of the cover, then prying
gently to release the cover from the top
snap.
Note: Keep the tow eye cover in a safe
place so you can replace it when towing is
complete.
Model S Owner's Manual