Installing And Configuring Your Hub; Verify Included Parts; Connect The External Transceiver; Verify The Hub Operates Correctly - HP J3188A Installation And Reference Manual

Installing the Hub

Installing and Configuring Your Hub

Installing and Configuring Your Hub
To install and configure your hub, you must complete five basic tasks. They
are:

1. Verify included parts

Each Hub-16M has the following components shipped with it:

2. Connect the external transceiver

Because of the way the external transceiver protrudes out from hub once it is
connected, you may want to install the external transceiver before installing
the hub. Inspect your installation site and identify whether enough room will
be available for the external transceiver to be connected. Then see your
external transceiver guide for installation instructions.

3. Verify the hub operates correctly

Before mounting the hub, connect it to a power source and verify the hub will
operate correctly.
1-2
locating and verifying the necessary parts
connecting an external transceiver (if necessary)
connecting the hub to a power source
mounting the hub
connecting the hub to your network
HP 10Base-T Hub-16M (J3188A) Installation and Reference Guide—
this manual (J3188-90001)
A U.S./Canada/Mexico (8120-1378) power cord.
Accessory kit (5064-2053):
• bumper feet (4)
• hub-to-rack screws 10-32 (4)
• bracket-to-hub screws 10-32 (4)
• nylon finishing washer (4)
• bracket-to-hub screws (2)
• AUI retainer assembly