Page 1
USER GUIDE PRESYS I | PRESYS II fishman.com...
Page 2
1. Set the controls • Set volume off and the contour control to off (button out). 2. Plug in • Connect the Presys I to an amplifier or PA with a ¼-inch instrument cable. The light will flash once quickly to indicate it has switched on.
Page 3
Presys I Controls Volume • For the cleanest signal, set the volume knob as high as possible, without causing distortion or feedback. Contour • This one-button tone control lets you choose between a natural sound with no EQ (button out) or a “Scooped” sound with emphasized treble and bass and reduced midrange (button in).
Page 4
Presys II Quick Start 1. Set the controls • Set volume off and bass and treble controls to center. 2. Plug in • Connect the Presys II to an amplifier or PA with a ¼-inch instrument cable. light will flash once quickly to indicate it has switched on. 3.
Page 5
Presys II Controls Volume • For the cleanest signal, set the volume knob as high as possible, without causing distortion or feedback. Bass • Boost here to add depth and weight to the sound of the guitar. Treble • Boost to cut through the mix. Cut to mellow and subdue the sound. Phase •...
Page 6
NOTE: FISHMAN TRANSDUCERS is not responsible for unauthorized equipment modifications that could violate FCC rules, and/ or void product safety certifications. EU Declaration of Conformity CE: Hereby, Fishman declares that these Onboard Preamps are in compliance with the essential requirements and other relevant provisions of Directive 2014/30/EU. The Declaration of Conformity can be found at: www.fishman.com/support.