Connection - JVC KD-SR72 Instruction Manual

Wiring connection
IMPORTANT
We recommend installing the unit with a commercially available
custom wiring harness specific for your car and leave this job to
professionals for your safety. Consult your car audio dealer.
Vehicle
dashboard
Factory wiring
harness (vehicle)
Custom wiring harness
(separately purchased)
Blue: To power antenna
Blue/white: To amplifier
* 2
You can also connect
a subwoofer speaker
directly using this
lead without an
external subwoofer
amplifier. For setting,
Connection via
speaker leads, 13.
Recommended connection
Output terminals
Antenna terminal
To the steering wheel Light blue/yellow
remote control adapter
STEERING
WHEEL
REMOTE
Join the same color wires together.
Blue/white: Remote (200 mA max.)
Orange/white: Illumination
Brown: Tel muting
Yellow: Battery 12 V
Red: Ignition 12 V
Black: Ground
Gray: Front speaker (right)
Gray/black
White: Front speaker (left)
White/black
Purple: Rear speaker (right)
Purple/black
Green: Rear speaker (left) *
Green/black *
Signal cord (not supplied)
Fuse (10 A)
Ignition switch
Separate red wire
Make this connection if
your vehicle factory wiring
harness does not have "12 V
ignition switch" wire.
2
2
* 1
Firmly connect the ground wire
of the amplifier to the car's
chassis to avoid damaging the
1
JVC Amplifier *
unit.
Part list for
installation
Remote wire
(not supplied)
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
Car fuse block
(D) Wiring harness
(E) Extraction key
ENGLISH
21