Axis-Specific Setting Data - Siemens Sinumerik 802D sl Programming Manual

04.07
D.3

Axis-specific setting data

43120
MD number
Default setting: 1
Changes effective IMMEDIATELY
Data type: DWORD
Meaning:
43240
MD number
Default setting: 0
Changes effective immediately
Data type: DOUBLE
Meaning:
43240
MD number
Default setting: 0
Changes effective IMMEDIATELY
Data type: DOUBLE
Meaning:
© SIEMENS AG 2007 All rights reserved
SINUMERIK 802D sl/840D sl840D/840Di sl/840Di/810D ISO Turning - - 04.07 Edition
DEFAULT_SCALE_FACTOR_AXIS
Default axial scale factor for G51 active
Minimum input limit: - -99999999
Protection level: 7/7
This machine data applies in combination with external programming languages. It is
effective with $MN_MM_EXTERN_LANGUAGE = 1.
If no axial scale factor I, J or K is programmed in the G51 block,
DEFAULT_SCALEFACTOR_AXIS is effective.
This MD is valid only if MD AXES_SCALE_ENABLE is set.
M19_SPOS
Spindle position in degrees for spindle positions with M19
Minimum input limit: - -359.999
Protection level: 7/7
The setting data is also effective in Siemens mode.
M19_SPOS
Position of spindle (degree) when commanding M19
Minimum input limit: - -359.999
Protection level: 7/7
Das Settingdatum ist auch im Siemens- -Mode wirksam.
Machine and Setting Data
D.3 Axis-specific setting data
Maximum input limit: 99999999
Unit: - -
Applies with effect from SW version: 5.2
Maximum input limit: 359.999
Unit: - -
Applies with effect from SW version: 5.2
Maximum input limit: 359.999
Unit: - -
Applies with effect from SW version: 5.2
D-219