Preparing The Battery; Charging The Battery Pack; Attaching The Battery Pack - Sony Handycam NEX-VG10E Operating Manual

Preparing the battery

Charging the battery pack

Charge the battery pack using the supplied battery
charger. You cannot charge the battery pack
attached on the camcorder.
1
Insert the battery pack into the battery charger.
2
Connect the battery charger to the wall outlet
(wall socket).
The CHARGE lamp lights up.
Lit: The battery is being charged.
Off: Normal charge is completed.
An hour after off: Full charge is completed.
CHARGE lamp
Power cord (mains lead)
Charging time
The following table shows the charging time in
minute required to charge a fully depleted battery
pack at a temperature of 25 °C (77 °F). The
charging time varies depending on the operating
conditions. See page 35 on the recording time
available.
Battery pack Full charge
NP-FV70 550
(supplied)
14
GB
to the wall outlet (wall
socket)
Normal charge
490
Battery pack Full charge
NP-FV100 960
• We recommend charging the battery pack in an ambient
temperature of between 10 °C and 30 °C (50 °F and 86 °F).
You may not be able to efficiently charge the battery pack
outside of this temperature range.

Attaching the battery pack

Press the battery pack against the back of the
camcorder, and slide it up until it clicks.
Checking the remaining battery level
Check the level with the following indicators
displayed on the LCD monitor or viewfinder.
Battery level
"Battery exhausted" You cannot record
any more images.
Note
• The displayed level may not be correct under certain
circumstances.
Normal charge
900
High
Low