Advertisement
WARNING:
The unit of measure mg/dL must be displayed here. If
your display shows mmol/L rather than mg/dL, contact
customer service at 1800 225544 or 022-30845544
(07:00 AM - 11:00 PM) or visit http://www.onetouch.co.in.
You cannot change the unit of measure. Use of the wrong unit
of measure may cause you to misinterpret your blood glucose
level, and may lead to incorrect treatment.
CAUTION:
• If your blood glucose is high and you test when the
temperature is at the low end of the operating range 10°C,
the result on your meter may be lower than your actual
glucose level. Re-test in a warmer environment with a new
test strip as soon as possible.
• Do Not make immediate treatment decisions based on
whether your results fall within one of these pre-set ranges.
• Treatment decisions should be made based on the numerical
result and your healthcare professional's recommendations.
• Consult with your healthcare professional as to how the
pre-set ranges defined by the two dots on your meter apply
to your personal target range.
Error Messages
If you get an ERROR message on your screen rather than a result,
see Troubleshooting in Section E.
After getting a result
Remove the test strip from the meter and the meter will turn off.
Removing the used lancet
Remove the lancing device cap by
snapping it off. Cover the exposed lancet
tip before removing the lancet. Place the
lancet protective cover on a hard surface.
Push the lancet tip into the cover. Remove
the lancet and place it in a container for
sharp objects. Replace the cap.
Disposing of the used lancet and test strip
It is important to discard the used lancet carefully after each
use to avoid unintended lancet stick injuries. Used test strips
and lancets may be considered biohazardous waste in your
area. Be sure to follow your local regulations or your healthcare
professional's recommendations for proper disposal.
8
Hide quick links:
Advertisement
