Features - Peavey Invective MH Operating Manual

Peavey Invective
®
Congratulations on the purchase of your new Invective MH tube guitar amplifier from Peavey! Although small, this amp has an all-
tube preamp and power amp to authentically produce the much loved tones of the Invective 120-- albeit at lower power levels. The
major advantage is the sheer size and weight (or lack thereof).
Before you begin playing through your amplifier, it is very important to ensure that the product has the proper AC line voltage
supplied. This is shown on the voltage selector switch near the IEC inlet on the rear panel of the unit. Refer to the rear panel diagram
in this manual to locate the particular feature next to its number.
Please read this guide carefully to ensure your personal safety as well as the safety of your amplifier. A careful reading of this manual
will also ensure you get the best out of your amplifier, by fully understanding its many features.

FEATURES:

• 2x EL84 power tubes and 3x 12AX7/ECC83 preamp tubes
• Clean Channel with Low and High EQ.
• Lead Channel with 3 band EQ.
• Footswitchable Tight on Lead channel.
• Footswitchable Gate and Boost on Lead Channel.
• Footswitchable buffered effects Loop
• Tube Status Indication (T.S.I.) circuit
• Impedance switch for 16 or 8 ohm cabinets
• MSDI™ Output with XLR and ground lift switch
• USB Output
• Speaker defeat switch
• Headphone output
• Attenuator switch for 20 watts, 5 watts or 1 watt output power
• Master Resonance and Presence.
VENTILATION: For proper ventilation, allow 24" clearance from the nearest combustible surface.
All vents should have a minimum of 2" of free air space so air can flow thru the unit freely for proper cooling.
ENGLISH
MH
®