Folding And Transport - Chicco Pocket Snack Instructions For Use Manual

the tray alone does not guarantee the
safe containment of the child. Always
use the safety belts!
• Do not open and close the booster seat
when the child is sitting on it.
ADVICE FOR CLEANING AND MAINTENANCE:
Cleaning and maintenance operations must be carried
exclusively by an adult.
Check the booster seat on a regular basis for any cracks,
damage or missing parts; if anything is visible or not
working correctly do not use the seat.
Clean the plastic parts with a water dampened cloth.
The tray can be washed in the dishwasher.
INSTALLATION:
1. Unhook the lower fastening straps as shown in figure 1;
2. Detach the tray from the booster seat, by pulling
outwards on the relative side handles, as shown in figure 2;
3. Lift the backrest as shown in figure 3 and lock it in the
vertical position (you will hear a ''click'' indicating the
right position has been reached).
4. The booster seat can be adjusted to 3 different heights;
to raise the seat height, after removing the child from the
booster seat, grasp the seat and pull it upward, making
sure to act as counter-weight, grabbing one of the front
feet (figure 5). You will hear a ''click'' at each position,
to confirm the proper locking of the seat at the required
height.
To lower the height, press and slightly pull forward the
button located under the seat as shown in figure 6.
WARNING: Always perform these operations after
removing the child from the booster seat.
5. Position the seat on the chair (figure 7); to use this
product, the chair should have the minimum sizes
indicated in figure 8. Attach the rear fastening straps,
by passing them behind the chair's backrest, as shown in
figure 9, and the lower fastening straps around the seat as
shown in figure 10; make sure to hear a "Click", to indicate
the proper locking.
Pull the free end of the lower and rear straps to adjust the
length, until they are properly pulled tight and the seat is
securely anchored to the chair (figure 11).
6. Once the booster seat is fastened securely to the chair's
seat and backrest, you can place your child in to it as
follows:
a. Unfasten the buckle of the three-point safety belts as
indicated in figure 12A.
b. Position the child on the booster seat, fastening them in
with the safety belts. Check that the belts and buckle are
fastened properly (figure 12B).
7. Attached the tray to the booster seat side supports,
pulling outwards on the relative side handles, securing
it through the central fastening buttons located on
both sides of the booster seat (see figure 13A/13B). The
stabilisers present to the sides of the central fastening
button are used to stabilise the tray; make sure that the
tray is fastened to the central fastening button in at least
one point, and never just to the stabilisers only (figure
13C). The tray can be adjusted in 3 different positions
(figure 13D).

FOLDING AND TRANSPORT

8. Detach the tray, pulling outwards on the relative side
handles as explained in point 2.
9. Adjust the seat bringing it to the lowest point, as
explained in point 4.
10. Press the backrest's locking buttons located on the
arms of the booster seat at the same time, and pull the
arms forward until the backrest is completely folded
(figure 14).
11. Secure the tray to the buttons, positioning it as shown
in figure 15, in order to make the product as compact as
possible for transport.
12. Fasten the lower fastening straps, passing them over
the tray as shown in figure 16.
13. It is possible to conveniently transport the seat using
the rear straps as shown in figure 17. To do so, adjust
the length of the straps, as needed. Alternatively, use
the transport handle located on the rear side of the seat
(figure 18).
16