Troubleshooting Guide; Repair And Maintenance - Razor Dirt Rocket SX500 Owner's Manual

REPAIR AND MAINTENANCE

Battery Care and Disposal
Never store the product in freezing or below freezing temperatures! Freezing will permanently damage the battery. Failure to
recharge the battery at least once a month may result in a battery that will no longer accept a charge.
CONTAINS SEALED LEAD ACID BATTERIES. BATTERIES MUST BE RECYCLED.
Pb
Disposal: Your Razor product uses sealed lead-acid batteries which must be recycled or disposed of in an environmentally
safe manner. Do not dispose of a lead-acid battery in a fire; the battery may explode or leak. Do not dispose of a lead-acid
battery in your regular household trash.
Charger
The charger supplied with the electric motor bike should be regularly examined for damage to the cord, plug, enclosure and
other parts, and in the event of such damage, the product must not be charged until it has been repaired or replaced.
Use ONLY with the recommended charger.
Wheels
Wheels and drive system are subject to normal wear and tear. It is the responsibility of the user to periodically inspect wheels
for excess wear and adjust and replace drive train components as required.

TROUBLESHOOTING GUIDE

Unit should be fully charged prior to doing any troubleshooting and must be done by an adult ONLY.
Problem
Does not work
No longer works
Possible Cause
Battery not fully charged
Loose connection(s)
Burnt-out fuse
Motor or electrical switch damage
Loose connection(s)
Charger not working
Battery will not hold a charge
Solution
Charge unit for a full 12 hours.
Check for loose connections/wires.
Check power to wall outlet and/or try a different outlet.
The fuse will burn out and automatically shut off the power if the motor is
overloaded.
An excessive overload, such as too heavy a rider or too steep a hill, could
cause the motor to overheat. Replace the fuse(s) with a new one of equal
amperage. Correct the conditions that caused the fuse to burn out and avoid
repeatedly burning out fuse.
Contact customer service.
Check for loose connections/wires.
Check power to wall outlet and/or try a different outlet.
Check lights on charger:
Plugged into wall - Green
Plugged into wall & unit - Red (charging)
Plugged into wall & unit - Green (charging complete)
No lights/Blinking lights - Replace Charger
Secure unit, turn power ON with no weight on the unit, carefully lift up back
end and apply the throttle to engage the motor. If motor engages - replace
battery.
If motor does not engage, but makes a clicking sound - Replace Battery. If
motor does not engage, no clicking sound - Replace Control Module.
11
WARNING: If a battery leak
develops, avoid contact with the
leaking acid and place the damaged
battery in a plastic bag. Refer to the
disposal instructions at left. If acid
comes into contact with skin or eyes,
flush with cool water for at least 15
minutes and contact a physician.
WARNING: Battery posts,
terminals and related accessories
contain lead and lead compounds.
Wash your hands after handling.