Husqvarna 550iBTX Operator's Manual page 15

3. Install the battery in the backpack holder.
4. Push the locking handles to lock the battery.
5. Connect the cable to the connector.
6. Put the cable in the clip on the backpack holder.
To start the product
1. To start the backpack battery, push the start button
on the backpack battery. Do not continue with the
steps that follow before the green LED lights is on.
Note: When the backpack battery starts, there is a
startup time of approximately 4 seconds. During the
startup the fans come on and green LED lights on
the battery flashes. When the green LED lights on
the battery are on, the product is prepared for start.
2. Push and hold the start button until the green LED
lights on the user interface come on.
To stop the product
1. Release the power trigger.
2. Push and hold the stop button until the green LED
light goes out.
3. Remove the cable from the clip on the packpack
holder.
790 - 001 - 05.12.2018
4. Pull the locking handles to unlock the battery.
5. Disconnect the cable from the connector.
6. Remove the battery from the product.
Note: If the backpack battery is not used for more than
30 minutes, the backpack battery stops automatically.
To start the backpack battery, push the start button on
the backpack battery.
To operate the product
1. Push the power trigger to select the optimal airflow
for your work.
2. Push the Cruise control button to set the selected
airflow, the LED comes on.
3. Continue to operate with the selected airflow without
the power trigger.
4. To increase the airflow, push the power trigger.
When the power trigger is released, the airflow goes
back to the airflow that was set in step 2.
15