Sony HAP-Z1ES Help Manual page 141

Help Guide
How to Use
HDD AUDIO PLAYER
HAP-Z1ES
Operating an amplifier manufactured by another company using the supplied remote control or a dedicated
application
If you register the remote control supplied with a connected amplifier manufactured by another company to the HDD
AUDIO PLAYER, you can perform operations such as turning on/off the amplifier, adjusting the volume and muting the
sound through the remote control supplied with the HDD AUDIO PLAYER or the HDD Audio Remote application.
1. Select [Settings] - [Amp Control Settings] in the Home screen.
2. Confirm the description about the AMP Control Settings, and then select [Next].
The current settings are displayed.
Not learned: a function that has not been learned yet
In use: a function that has been learned and is to be used
Not in use: a function that has been learned but is not to be used
3. Select [Next].
A screen to select the manufacturer of the connected amplifier appears.
4. Select [Other].
5. Follow the instructions on the screen to connect the plug of the IR blaster (supplied) to the IR REMOTE OUT jack of
the HDD AUDIO PLAYER and place the other side of the IR blaster (the side to radiate infrared) close to the the
remote sensor of the amplifier, and then select [Next].
6. Select a function you want the HDD AUDIO PLAYER to learn from functions indicated as [Not learned].
The [Learning...] status appears.
7. While [Learning...] is displayed, aim the remote control of your amplifier at the remote sensor of the HDD AUDIO
PLAYER and press the button of the function being learned, such as the power button.
The HDD AUDIO PLAYER learns this function of the remote control of your amplifier. When the learning is
completed, the Learning Complete screen appears.
8. If you want to test the connection to confirm that the learning has been completed, select [Yes].
9. Confirm the instructions on the screen and then select [Start].
The connection test starts.
10. When you have confirmed that no problems have been found in the test, select [Finish Test].
The screen returns to the list of the settings. If you want to configure another function, select the function and
141