Sony Handycam DCR-HC26E Operating Manual page 11

5
The CHG (charge) lamp turns off
when the battery is fully charged.
Disconnect the AC Adaptor from
the DC IN jack.
For DCR-HC35E:
Disconnect the AC Adaptor from the
DC IN jack holding both the Handycam
Station and the DC plug.
For DCR-HC35E:
To charge the battery pack using only
the AC Adaptor
Slide the POWER switch to OFF(CHG).
Then connect the AC Adaptor directly to
the DC IN jack on the camcorder.
• You can operate your camcorder connected to a
power source such as a wall socket as shown in
the illustration. The battery pack will not lose its
charge in this case.
POWER switch
With the v mark
facing to the
LCD screen
DC plug
To the wall socket
Mains lead
DC IN jack
AC Adaptor
For DCR-HC35E:
To remove your camcorder from the
Handycam Station
Turn off the power, then remove the
camcorder from the Handycam Station
holding both your camcorder and the
Handycam Station.
For DCR-HC23E/HC24E/HC26E:
To use an outside power source
You can operate your camcorder using the
power from the wall socket by making the
same connections as you do when charging
the battery pack. The battery pack will not
lose its charge in this case.
To remove the battery pack
1 Slide the POWER switch to
OFF(CHG). Hold down the V
BATT(battery) release lever with one
hand.
11
Continued ,