Hex Capscrew; Washer (High Temp) - Johnson Controls Y20EBD Series Technical Bulletin

Actuator and
Linkage
Mounting
Actuator
14 M Motor Actuators
—

Hex Capscrew

Temperature
Figure 12: Mounting Motor Actuator
1. Locate the load end over the yoke.
2. Mount the actuator onto the brackets using the four bolts and nuts, but
do not tighten.
Note: If the temperature of the valve or its media is high enough to raise
the actuator temperature above its limit of 125°F (52°C), insert the
four white insulating washers (provided with the linkage kit)
between the actuator and the brackets. For lower temperature
applications, omit the insulating washers.
Y20EBD Valve Linkage for M100 Motor Actuators
High
Washer
Nut
Y20D1-12
M100
Motor
Actuator