Monitoring The Camera Image; Using The Msu-900/950; Connections - Sony F35 Cinealta Operation Manual

Monitoring the Camera Image

Settings on this camera
Set RM [SIG] to VBS on the <MONITOR OUTPUT>
page of the USER (OPERATION) menu.
Settings on the RM-B750
Press the MONITOR button. The camera image will be
displayed on the display of the RM-B750.
VBS signals are fed to an external monitor if connected via
the MONITOR connector of the RM-B750.
110

Using the MSU-900/950

Using the MSU-900/950
You can adjust this camera from the MSU-900/950 Master
Setup Unit via a network.
You can use either Bridge mode to control a camera from
an exclusive MSU-900/950 or Multi mode to control
multiple cameras from one MSU-900/950 or from multiple
remote controllers, including the MSU-900/950 via a
HUB.

Connections

Bridge mode
For using one camera on a network.
Using a LAN cable, connect the MSU-900/950 to the
(network) connector of this camera.
You may use the remote cable connection simultaneously.
Example
REMOTE
REMOTE
PANEL STANDARD MONITOR TEST BARS
ACTIVE
MEMORY
5600K AUTO SKIN BLACK KNEE
STICK
KNEE DETAIL GAMMA SATURATION
FUNCTION
MAINTE
NANCE
SCENE
PAINT
IRIS
ALARM
REMOTE CONTROL UNIT
RM-B750
Multi (MCS) mode
Connect the LAN cable connected to the
connector of this camera to the HUB.
You may use the remote cable connections simultaneously.
Notes
• Remote cable connections will be invalid if the master
unit is not connected to the same network.
• If the master-specified MSU-900/950 is off, all the
network/remote communications are disabled.
• Do not connect devices having the same IP address to the
network.
• Do not connect cameras having the same ID number to
the network. Communications would be disabled on
both cameras.
MSU-900/950
CLOSE VTR
START/STOP
ABB
AWB
WHITE
ABS
BLACK
AUTO IRIS/MB
IRIS ACTIVE MASTER
BLACK
EXT
(network)