Rear And Side Cargo Doors; H A N D Le; Hinge S T R A P; Hinge Stop - Chevrolet 30 Series 1967 Service Manual

BODY IB-24
The optional window glass in the rear and side cargo
doors may be replaced as outlined on Page 14.
The front side door window glass may be removed and
installed as outlined below:
Removal
NOTE: Do not remove arm rest.
1. Remove window regulator handle, door inside handle
and remove trim panel as indicated under "Trim
Panel and Hardware" above.
2. Remove door bottom channel retainer screw (fig. 55).
3. Roll window to full down position and push rear
channel retainer to one side (fig. 56).
4. Tilt window glass forward and disengage regulator
roller from guide rail (fig. 57).
5. Tip rear edge of glass upward and remove (fig. 58).
Installation
1. With regulator arm in full down position, insert
glass (vent side downward).
2. Move the regulator up approximately two turns of the
handle and slide roller onto guide.
3. Reposition metal channel retainer and adjust screw
so glass operates smoothly.
4. Install trim panel and hardware.
Door Lock Striker A djustm ent
Same as Conventional Cab.

REAR AND SIDE CARGO DOORS

Rear Door Lock, Rod Assembly and Handle (Fig. 59)
Replacement
1. Remove the rod assembly attaching snap on clips
(with a screw driver) located as shown in Figure 59
through the access hole. New clips must be used on
reassembly of the rod. .
2. Remove the rod assemblies and special spring clips
(not shown) attached at the door rod opening in each
end of the door.
3. Remove the inside handle set screw, handle and
washer.
4. Remove the lock assembly attaching screws, rotate
the lock and remove through the access hole.
5. Reverse removal procedure to install.
The forward load door is serviced the same as rear
doors (fig. 60).
Rear Door Outside Handle (Fig. 61)
Replacement
1. Remove spring retainer from inside door panel
Fig. 54 - Trim Panel and Hardware
Fig. 55 - Bottom Channel Retainer Screw
opening.
NOTE: Removal of lock assembly is not neces­
sary for handle removal. Access to the lock
cylinder retainer is through the inside door
panel for removal.
2. Remove handle and spring.
NOTE: While handle is removed, the escutch­
eon and gasket can be removed.
3. Reverse procedure to install.
Hinge Strap (Fig. 62)
Replacement
The hinge strap is replaceable by pulling the strap re­
lease pin and removing two screws from the strap bracket
on the door.

Hinge Stop

The hinge stop is replaceable by removing the hinge
Fig. 56 - Channel Assembly Attachment
CHEVROLET TRUCK SERVICE MANUAL