Sony DCR-TRV Operating Instructions Manual page 161

Connecting your camcorder to your computer using the USB cable
– For Windows users
(11) Follow the on-screen messages so that the Add Hardware Wizard recognizes
that the USB drivers have been installed. The Add Hardware Wizard starts
three times because three different USB drivers are installed. Be sure to allow
the installation to complete without interrupting it.
For Windows 2000 Professional, Windows XP Home Edition/Professional users:
(12) After the "File Needed" screen appears.
Open "Browse..." t "My Computer" t "ImageMixer" t "Sonyhcb.sys",
and click "OK".
Viewing images recorded on a "Memory Stick"
– Except DCR-TRV16
Before operation
Set USBCONNECT in
(The default setting is NORMAL.)
(1) Insert a "Memory Stick" into your camcorder.
(2) Connect the AC power adaptor and set the POWER switch to MEMORY.
(3) Connect the
computer using the supplied USB cable.
"USB MODE" appears on the LCD screen of your camcorder. Your computer
recognizes the camcorder, and the Add Hardware Wizard starts.
(4) Follow the on-screen messages so that the Add Hardware Wizard recognizes
that the USB drivers have been installed. The Add Hardware Wizard starts
two times because two different USB drivers are installed. Be sure to allow
each installation to complete without interrupting them.
You cannot install the USB driver if a "Memory Stick" is not in your camcorder.
Be sure to insert a "Memory Stick" into your camcorder before installing the USB
driver.
to NORMAL in the menu settings.
(USB) jack on your camcorder with the USB jack on your
(USB) jack
Push into the end
USB jack
USB cable (supplied)
161