Cisco QSFP-H40G-CU5M Installation Note page 14

Attaching the Optical Network Cable
The multiple-fiber push-on (MPO) connectors and the duplex LC connectors on the optical QSFP+
Note
transceivers support network interface cables with either physical contact (PC) or ultra-physical contact
(UPC) flat polished face types. The MPO and duplex LC connectors on the optical QSFP+ transceivers
do not support network interface cables with an angle-polished contact (APC) face type.
Step 1 Remove the dust plugs from the optical network interface cable MPO connectors. Save the dust plugs
for future use.
Inspect and clean the MPO or duplex LC connector's fiber-optic end faces. See the Tip below for a
Step 2
pointer to a fiber-optic inspection and cleaning white paper.
Tip
Remove the dust plugs from the QSFP+ transceiver module optical bores.
Step 3
Step 4 Immediately attach the network interface cable MPO connector (see
(see Figure
Figure 5
Cisco 40-Gigabit QSFP+ Transceiver Modules Installation Note
14
For complete information on inspecting and cleaning fiber-optic connections, see this URL:
http://www.cisco.com/en/US/tech/tk482/tk876/technologies_white_paper09186a0080254eba.
shtml
6) to the QSFP+ transceiver module.
Cabling a 40-Gigabit QSFP+ Transceiver Module Equipped with an MPO Connector
Figure 5) or duplex LC connector
OL-24862-01