Removing The Xenpak Transceiver - Cisco DWDM-XENPAK Series Installation Notes

Figure 3
SC connector
Network interface
Figure 4
CAB-INF-28G-5

Removing the XENPAK Transceiver

The 10-Gigabit XENPAK transceiver is a static-sensitive device. Always use an ESD wrist strap or
Caution
similar individual grounding device when handling the XENPAK transceivers or coming into contact
with the modules.
If you are removing a 10-Gigabit XENPAK transceiver, follow these steps:
Disconnect the network fiber-optic cable from the 10-Gigabit XENPAK transceiver connectors.
Step 1
Immediately reinstall the dust plugs in the XENPAK transceiver optical bores and the fiber-optic cable
SC connectors.
Loosen the two captive installation screws that secure the XENPAK to the module.
Step 2
78-15665-07
Cabling an Optical XENPAK Transceiver Module
XENPAK
cable
Cabling a CX4 (Copper) XENPAK Transceiver Module
4X InfiniBand
connector
1
L I N
K
2
L I N
K
A C
T I
V E
XENPAK-10GB-CX4
Cisco 10-Gigabit Ethernet XENPAK Transceiver Modules Installation Note
Removing the XENPAK Transceiver
15