Labeling A Cassette - Sony Handycam DCR-PC10E Operating Instructions Manual

Labeling a cassette

If you use a tape with cassette memory, you can
label a cassette. The label can consist of up to 10
characters and is stored in cassette memory.
When you insert the labeled cassette and turn the
power on, the label is displayed on the LCD
screen, in the viewfinder or on the TV screen.
(1) Insert the cassette you want to label.
(2) While pressing OPEN, open the LCD panel.
(3) Set the POWER switch to VTR.
(4) Press MENU to display the menu on the LCD
screen.
(5) Turn the control dial to select TAPE TITLE,
then press the control dial.
(6) Turn the control dial to select the column of
the desired character, then press the control
dial.
(7) Turn the control dial to select the desired
character, then press the control dial.
(8) Repeat steps 6 and 7 until you finish the label.
(9) Turn the control dial to select [ ], then press
the control dial.
To erase a character
In step 7 turn the control dial to select [M], then
press control dial. The last character is erased.
To change the label you have made
Insert the cassette to change the label, and
operate in the same way to make a new label.
If the mark appears in step 5
The cassette memory is full. If you erase the title
in the cassette, you can label it.
If you have superimposed titles in the cassette
When the label is displayed, up to 4 titles also
appear.
Note on "-----" indicator displayed on the LCD
screen or in the viewfinder
The "-----" indicates the number of characters
you can select for the label.
Note on the cassettes
If you use a cassette tape set to prevent accidental
erasure, you cannot label it. Slide the protect tab
so that the red portion is not visible.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
M
81