Maintenance - Ryobi P738 Operator's Manual

TURNING THE INFLATOR ON/OFF
See Figure 2, page 7.
 To turn the inflator on and begin the flow of air, pull the
switch trigger all the way and release it.
 Repeat the above step to turn the inflator off.
INFLATOR NOZZLES
See Figure 3, page 7.
 To install the large nozzle: Slide the wide end of the
nozzle onto the tool. The tab on the tool should slide into
the slot on the nozzle. Turn the nozzle counterclockwise
until the nozzle is secure.
 To install the small nozzle (pinch valve adaptor): Slide
the wide end of the nozzle onto the end of the large nozzle
until it is securely attached.
NOTE: When not in use, the small nozzle can be stored
on the base of the tool.
The inflator can be hung on a pegboard by the hole on the
back of the tool housing.
NOTICE:
Do not block the deflation port on top of the inflator. This
can cause overheating and damage the unit.
NOTICE:
Always leave the nozzle free of obstructions when the
tool is not in use. Overheating could occur if the nozzle
is blocked.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts can create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
NOTE: ILLUSTRATIONS START ON PAGE 7 AFTER FRENCH AND
OPERATION

MAINTENANCE

SPANISH LANGUAGE SECTIONS.
6 — English
INFLATING
See Figures 4 - 5, page 7.
 Select and install the nozzle that fits your application.
 Insert the nozzle into the air port on the inflatable item.
 Pull and release the switch trigger to start the inflator. The
inflator will continue to run until it is turned off.
 When the item is fully inflated, pull and release the switch
trigger to stop the flow of air.
 Remove the nozzle from the inflated item and close the
item's air port.
NOTE: Maximum PSI for this unit is 0.5 PSI.
DEFLATING
See Figure 6, page 7.
 Insert the large nozzle into the deflation port on top of the
tool.
 Insert the nozzle into the air port on the inflatable item.
 Pull and release the switch trigger to start the inflator. The
inflator will continue to run until it is turned off.
 When the item is fully deflated, pull and release the switch
trigger to stop the tool.
 Remove the nozzle from the deflated item and close the
item's air port.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which can result in serious personal injury.