Water Drainage; Maintenance - Amcor AC12 User Manual

WATER-DRAINAGE
MANUAL DRAINAGE
When the internal water tank is full the unit will stop working.
Shut off the unit and unplug. Avoid moving the model abruptly as
this may cause water to spill from the internal tank.
Place a tray under the water plug.
Unscrew the Drain plug cap and remove the rubber stopper - water
will drain from the internal tank.
Put the rubber stopper back and screw the drain plug cap back into
place.
CONTINUOUS DRAINAGE:
Unscrew the drain plug cap and remove the rubber stopper. Fit the
drain connector within the cap
Connect a suitable pipe to the water outlet to remove the water out
continuously.
Note: This model is self-evaporative, which reduces the need to empty
the water tank.
If the unit is vented correctly most of the water is reused to cool the
condenser coils and any excess is evaporated.
Please do not use continuous drainage if you intend to use the self-
evaporate facility.

MAINTENANCE

CLEANING
Turn off the unit and unplug from the mains before cleaning or performing any maintenance.
CLEAN THE SURFACE
Clean the plastic housing with a duster or a soft wet cloth.
Do not use chemical solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage.
AIR FILTER CLEANING
Clean the air filters every 2 weeks. If the air filter is blocked with dust, the performance of
the unit will be significantly affected.
Pull out the top and bottom filters as pictured below
Wash the air filters by immersing them in warm (about 40℃) water with a neutral detergent.
Rinse it and then dry it thoroughly.
Carefully re-install air filters
END OF SEASON MAINTENANCE
1. Pull out the plug from the drainage hole and empty the internal tank. You should ensure
the tank is fully drained by leaning the unit backwards.
2. Then switch the unit to Fan mode,
3. Keep the unit in this mode for half day. Doing this helps to keep the inside of the unit dry
and prevents mold developing
4. Turn off the unit and unplug
5. Ensure the water tank is empty before replacing the rubber bung and drain cap.
6. Coil the wire and bind it together, then put it into the accessories space.
7. Separate the air-exhausted pipe and store it safely.
8. Cover the unit and keep it in a dry place.
9. Take the batteries out of remote control and store, or dispose, them safely
9
Drain plug cap
Rubber stopper
Drain connector
Drain plug cap
Drain pipe
(size: 10 mm)