Resuming Recording In Cliplink Mode - Sony 500WSPL Operating Instructions Manual

ClipLink Shooting
6
To finish shooting, press the VTR button on the
camcorder or the lens.
This stops recording operation.

Resuming Recording in ClipLink Mode

During recording pause in ClipLink mode, pressing the
STOP/PLAY/F FWD/REW buttons, performing edit
search, or ejecting the cassette will interrupt the
ClipLink shooting. With this state, it is impossible to
start back space editing using ClipLink function. (The
ClipLink continue mode is canceled and indication
in the display window disappears.) If you resume
CONT
recording on the same cassette, the previously recorded
data will be overwritten.
1
1
4
1
Perform steps 2 to 10 in "Basic Procedure for
Shooting" (pages 49 and 50) and step 1 (page 53)
in "Recording on the Internal VCR".
2
Insert a cassette if one is not already loaded.
The and indications should appear in the
CL
display window.
Note
If the is flashing, it means abnormality of the
CL
cassette memory. In this case, it is impossible to
continue recording from that data on ClipLink
mode.
72
Chapter 3 Shooting
3
Time codes (HH:MM:SS) of recording start/stop
points (Rec IN/OUT points) and scene number
(scene 001) are recorded to the cassette memory
and the Index Picture of the Rec IN point is
recorded onto the tape (when the DSBK-301A is
fitted).
You can avoid this and continue recording in ClipLink
mode from the previous recording stop point by
performing the following steps.
Note
If you stop recording during the first ten seconds of
recording, you may not be able to use these steps to
continue recording in ClipLink mode.
2
3
Check the following points.
Result and response
Check point
CLIP and IP If these indications do not appear in
(when the DSBK- the display window, access the
301A is fitted) VCR menu and set ClipLink
appear in the function to on (see page 109).
display window
Remaining clips Make sure there are enough
capacity for recording clips (see
page 18).