Step 6: Preparing The Remote; Controlling Tvs With The Remote - Sony BLU-RAY DISC BDP-N460 Operating Instructions Manual

Step 6: Preparing the
Remote
You can control the player using the supplied
remote. Insert two Size AA (R6) batteries by
matching the 3 and # ends on the batteries
to the markings inside the battery
compartment. When using the remote, point
it at the remote sensor
(page 10).
b
• Use the batteries correctly to avoid possible
leakage and corrosion. Should leakage occur, do
not touch the liquid with bare hands. Observe the
following:
– Do not use a new battery with an old battery, or
batteries of different manufacturers.
– Do not attempt to recharge the batteries.
– If you do not intend to use the remote for an
extended period of time, remove the batteries.
– If battery leakage occurs, wipe out any liquid
inside the battery compartment, and insert new
batteries.
• Do not expose the remote sensor (marked
the front panel) to strong light, such as direct
sunlight or a lighting apparatus. The player may
not respond to the remote.
26
on the player
on
Controlling TVs with the
remote
You can control the volume, input source,
and power switch of your Sony TV with the
supplied remote.
b
When you replace the batteries of the remote, the
code number may be reset to the default setting. Set
the appropriate code number again.
TV INPUT
Number
buttons
Available buttons
Depending on the connected unit, you may
not be able to control your TV with some or
all of the buttons (TV [/1, TV INPUT, or
VOL +/–).
Buttons Operations
TV [/1
Turns your TV on or off.
TV INPUT (TV
Switches your TV's input
input select)
source between the TV
and other input sources.
VOL (volume) Adjusts the volume of
+/–
your TV.
To control other TVs with the remote
You can control the volume, input source,
and power switch of non-Sony TVs as well.
If your TV is listed in the table below, set the
appropriate manufacturer's code.
b
If you enter a new code number, the code number
previously entered will be erased.
TV [/1
VOL +/–