Sonos ZonePlayer ZP80 Setup Manual page 8

4
1-2-3 Setup
Note: The first ZonePlayer you install must connect to your home network using a
standard Ethernet cable (supplied). If you should experience any difficulty during
the setup process, please go to www.sonos.com/support for additional help.
IF you are setting up a new Sonos system
1
Attach the power cord and plug in the ZonePlayer ZP80.
2 Connect a standard Ethernet cable (supplied) from either of the two (2) Ethernet switch
connectors on the back of your ZonePlayer ZP80 to an open port on your router (see A in
the diagram below). Do not connect the ZonePlayer directly to your cable or DSL modem
unless your modem has a built-in router.
• If you don't have a router, go to http://faq.sonos.com/norouter for instructions.
• If you don't have an open port on your router, you can disconnect your computer from
the router and connect it to the ZonePlayer ZP80 instead. Then connect the ZonePlayer
Sonos ZonePlayer ZP80 Setup Guide
If you have
structured (built-in)
wiring, connect the
Ethernet cable into a
live wall plate (see B
in the diagram).