Table 169 Ve-Name Command; Ve-Name - Nokia 7302 Manual

Virtual Private LAN Service
(2 of 2)
5.16.2.44
Table 169
(1 of 2)
276
Item Description
Description This command configures the allowed range for the VE-id value: locally configured and
received in a NLRI. Configuration of a VE-id higher than the value specified in this command
is not allowed.
Upon reception of a higher VE-id in an NLRI imported in this VPLS instance (RT=configured
import RT) the following action must be taken:
•
a trap must be generated informing the operator of the mismatch
•
NLRI must be dropped
•
no service labels are to be installed for this VE-id
•
no new NLRI must be generated if a new offset is required for VE-id
The no form of this command sets the max-ve-id to un-configured. The BGP VPLS status
should be administratively down for "no max-ve-id" to be used.
The max-ve-id value can be changed without shutting down bgp-vpls if the newly provisioned
value does not conflict with the already configured local VE-ID. If the value of the local VE-ID
is higher than the new maxve-id value, the command is rejected. the operator needs to
decrease the VEID before running the command.
The actions taken for other max-ve-id values are described below:
•
max-ve-id value higher than all VE-IDs (local and received) is allowed and there are no
effects
•
max-ve-id higher than the local VE-ID but smaller than the remote VE-IDs
•
provisioning is allowed
•
a warning message will be generated stating that "Higher VE-ID values were received
in the BGP VPLS context. Related PWs will be removed."
•
the PWs associated with the higher VE-IDs will be removed locally
•
this is a situation that should be corrected by the operator as the PW may be down just
at the local PE, unnecessarily consuming core bandwidth. The higher VE-IDs should
be removed or lowered.
If the max-ve-id had increased a BGP route refresh is sent to the VPLS community to get the
routes which might have been rejected earlier due to max-ve-id check. Default no max-ve-id is
not configured. A max-ve-id value needs to be provisioned for BGP VPLS to be in "no
shutdown" state.
Default no max-ve-id
Parameters value — Specifies the allowed range of [1-value] for the VE-id. The configured value must be
bigger than the existing VE-ids.
Values 1..65535

ve-name

ve-name command
Item Description
Syntax ve-name name
no ve-name
Context configure>service>vpls>bgp-vpls
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
Issue: 13