User-To-User Communication - Nokia 7302 Manual

Virtual Private LAN Service
•
•
•
•
5.8.2.5
The v-VPLS/VPLS behavior distinguishes between the user-side and network-side,
to secure control over MAC learning capabilities, and enable the ability to control
user-to-user communication. User-to-user communication can be enabled or
disabled, to allow or prevent user-to-user communications between residential ports.
The following CLI command syntax can be used to enable or disable user to user
communication for a v-VPLS/VPLS instance:
configure service vpls <service-id> [no] user-user-com
194
query-interval:
The configured default value for (dynamic) MR SAPs when these SAPs cannot
learn the query-interval from the received QUERY messages (for example,
because these are not filled in the QUERY message).
The system assumes an external querier is shutdown when no QUERY is
received during a period of (vpls_robust_count-1)
msg_query_response_interval
Note: a valid QUERY always carries a msg_query_response_interval
configure service vpls service-id igmp-snooping query-interval seconds
The no form of the command returns this value to the system default value
(125 s).
query-src-ip:
The specific IP source address used in IGMP queries.
configure service vpls service-id igmp-snooping query-src-ip ip-address
The no form of the command returns this value to the system default value
(0.0.0.0).
report-src-ip:
The specific IP source address used in IGMP reports.
configure service vpls service-id igmp-snooping report-src-ip ip-address
The no form of the command returns this value to the system default value
(0.0.0.0).
robust-count:
The configured default value for (dynamic) MR SAPs when these SAPs cannot
learn the robust-count from the received QUERY messages (for example,
because these are not filled in the QUERY message).
configure service vpls service-id igmp-snooping robust-count robust-count
The no form of the command returns this value to the system default value (2).

User-to-user communication

Network Ports (including Subtending ISAM ports) are
Note —
created in regular mode. If the port is later assigned to a
subtending NE, the port can be changed to residential in the
port extension table, and user-to-user communication can be
enabled in the v-VPLS instance.
3HH-11985-AAAA-TQZZA
FD 100/320Gbps NT and FX NT IHub Services Guide
×
vpls_query_interval +
Issue: 13