Top Panel - C&C TECHNIC PG-HD1X User Manual

Top Panel

1. Power/Battery Status:
"●"" "LED light
" " " "LED Flash
status.
Using the 9V battery singly without a 9V transformer, the
power LED status will flash when the voltage of battery go
down to about Low Voltage. (That is indicating the power
of batter will use up.)
2. Power On/Off: Push the Power SW up to power on your
device (The Power LED is light). Push the Power SW
down to power off your device (The Power LED is dark)
3. Resolution Switch: Support you at least 7 kinds of
resolution for choice. Please refer to "HD-SDI A Output
/HD-SDI B Output"
4. Pattern Switch Button: Switch the Pattern Mode that
you want to test. Please refer to "Appendix A: Pattern
Chart."
After you press the Pattern Switch Button, the sequence
of the pattern mode is from upper left to upper right then
from bottom left to bottom right.
1. Power/Battery Status
2. Power On/Off
3. Resolution Switch
4. Pattern Switch Button
Power on.
The battery is in low voltage
6