Table of Contents
Advertisement
73
Managing the Settings
Administrator Settings—Web Snapshots
To exit
Administrator
Settings, tap
Back.
To exit Settings
as such, tap
Exit.
Note that there
is no Cancel
function letting
you exit the
menu undoing
any changes you
have made.
Take care!
About snapshots
You may gain access to your video
system through its web interface, see
the Administration Guide for more.
From the web interface you may gen-
erate snapshots of the video stream
from your system. You may also
generate snapshots from the outgoing
video of the far end system.
However, you cannot take snapshots
unless you have set the Allow Web
Snapshots to ON, as shown here.
Snapshots cannot be taken if the call is
encrypted. Encryption will disable the
snapshot feature at both ends, regard-
less of the local settings of the Allow
Web Snapshots parameter.
The web snapshot feature applies to
Point-to-Point as well as MultiSite calls
(but to unencrypted calls only).
In this context a MultiWay call should
be regarded as a variant of Point-
to-Point call as it is the MCU who is
controlling the call and your system is
connected to the MCU as in a Point-
to-Point call.
Caution! There is no Cancel function
letting you exit the menu undoing any
changes you have made. Take care!
D1458217 User Guide Cisco TelePresence
Profile Series, Codec C-series, Quick Set C20
SX20 Quick Set, MX200, MX300
Produced: November 2013 for TC7.0
All contents © 2010–2013
Cisco Systems, Inc. All rights reserved.
Advertisement
Table of Contents
