Disassembly Of Machine Parts - Stoelting AUTOVEND Operator's Manual

M. Press the Clean button and let the auger rotate
for at least 30 seconds.
N. While the auger is rotating, scrub the hopper with
a clean brush.
O. Drain the water out of the machine.
If the water does not drain clear, repeat steps B
through E.
P. Press the Clean button again to stop the auger.
Q. Optional: Fill the hopper with about 2 gallons
of Stera-Sheen solution (prepared following
manufacturers instructions) and follow steps B
through E above.
Running the solution through the machine makes
cleaning parts easier after disassembly.

2.4 DISASSEMBLY OF MACHINE PARTS

Before using the machine for the fi rst time, complete
machine disassembly, cleaning, and sanitizing proce-
dures need to be followed. Routine cleaning intervals
and procedures must comply with the local and state
health codes. Inspection for worn or broken parts should
be made at every disassembly of the machine. All worn
or broken parts should be replaced to ensure safety to
both the operator and the customer and to maintain good
machine performance and a quality product. Check the
wear line on the auger fl ights on a regular basis (Fig.
2-7) and replace as needed. Frequency of cleaning must
comply with the local health regulations.
Wear Line
Figure 2-7 Auger Flight Wear
To disassemble the machine, refer to the following steps:
A. DISASSEMBLY OF FRONT DOOR
1. On the IntelliTec2™ control, press and hold the
Main Freezer Power button for three seconds to
turn the power off.
Owner's Manual #513698 Rev.1
NOTE
NOTE
Pull out spigot pins Pull out spigot pins
Figure 2-8 Spigot Pins
2. Pull out the spigot pins.
3. Remove the rosette caps from the bottom of the
front door
4. Remove the knobs on the front door and remove
the front door by pulling it off the studs.
5. Remove the spigots through the bottom of the
front door.
6. Remove all o-rings from parts by fi rst wiping off
the lubricant using a clean towel. Then squeeze
the o-ring upward to form a loop (Fig. 2-9). Roll
the o-ring out of the groove.
Figure 2-9 Removing O-Ring
B. DISASSEMBLY OF AUGER
1. Remove the front auger supports and bushings.
2. Remove the auger assemblies from the machine.
Pull the augers out of the freezing cylinder slowly.
As the augers are being pulled out, carefully
remove each of the plastic fl ights with springs.
3. Keep the rear of the augers tipped up once they
are clear of the freezing cylinder to prevent the
rear seal assemblies from dropping.
6 AUTOVEND Model Machines