Assembly; To Remove Or Install Battery Pack; Variable Speed; Switch Lock - Rockwell ShopSeries RS2317K Manual

CoRdleSS ImpaCt WRenCh
C) to Remove oR InStall BatteRy paCK (See Fig. B)
Depress the Battery Pack Latch (4) to release and
slide the battery pack out from your tool. After re-
charge, slide it back into your tool. A simple push and
slight pressure will be sufficient.
opeRatIon
Intended use
This tool is intended to tighten and loosen nuts within
the respective range of dimension

aSSemBly

CautIon:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
Always use the correct size socket for bolts and nuts.
An incorrect size socket will result in inaccurate and
inconsistent fastening torque and/or damage to the
bolt or nut.
Installing or removing socket (See Fig. C)
Align the socket with the four square sides and push
it onto the anvil of the tool until it locks into place. Tap
it lightly if required.
To remove the socket, simply pull it off.
1. on/oFF SWItCh (See Fig. d)
Press the On/Off switch to turn the tool on.
Release the on/off switch to turn the tool off.

2. vaRIaBle Speed

This tool has a variable speed switch that delivers
higher speed and higher torque with increased trigger
pressure. speed is controlled by the amount of switch
trigger depression.
WaRnInG: Do not operate for long periods
at low speed because excess heat will be
produced internally.

3. SWItCh loCK

The switch trigger can be locked in the OFF position.
This helps to reduce the possibility of accidental
starting when not in use. To lock the switch trigger,
place the direction of rotation selector in the center
position.
8
4. ReveRSIBle (See Fig.e1 e2)
For fastening the bolt/nuts, press the forward rotation
marked " " (lever is moved to the left).
For loosening bolt/nuts press the reverse rotation
marked " " (lever is moved to the right).
WaRnInG: never change the direction of
rotation when the chuck is rotating, wait until
it has stopped!
5. led lIGht
To turn on the light simply press the on/off switch.
When you release the on/off switch, the light will be
off.
LED light increases visibility-great for dark or
enclosed area.
attentIon! The LED light could not face to eyes
directly.
6. FaStenInG toRque
1) The proper fastening torque may differ depending
upon the kind or size of the bolt, the material of
the workpiece to be fastened, etc. The relation
between fastening torque and fastening time is
shown in the figures.
Hold the tool firmly and place the socket over the
bolt or nut. Turn the tool on and fasten for the
proper fastening time.
note:
• When fastening bolt/nut M8 (5/16") or smaller,
carefully adjust pressure on the switch trigger so
that the screw is not damaged.
• Hold the tool pointed straight at the bolt or nut.
• Excessive fastening torque may damage the bolt/
nut or socket. Before starting your job, always
perform a test operation to determine the proper
fastening time for your bolt or nut. Especially for
the bolt smaller than M8 (5/16"), perform the above
test operation to prevent the trouble on socket or
bolt, etc.
en