Alcove Or Closet Installation - GE GTDL740EDWW Installation Instructions Manual

wall is highly recommended (see illustrations below). Elbows allow
the dryer to sit close to the wall without kinking and or crushing the
transition duct, maximizing drying performance.
UL-LISTED FLEXIBLE METAL (FOIL-TYPE) TRANSITION DUCT
used AND where a 4" diameter can be maintained throughout the
entire length of the transition duct.
ducts that comply with the "Outline for Clothes Dryer Transition Duct
Subject 2158A" shall be used.
enclosed spaces.
Slide one end of the duct over the clothes dryer outlet pipe.
Secure the duct with a clamp.
With the dryer in its permanent position, extend the duct to its full length.
Allow 2" of duct to overlap the exhaust pipe. Cut off and remove excess
Secure the duct to the exhaust pipe with the other clamp.
ELBOW
REQUIRED
DO NOT USE
EXCESSIVE
EXHAUST
LENGTH
1" = 2.5 cm
1' = 0.3 m
Installation Instructions
DO
ELBOWS
REQUIRED
DON'T
DO NOT
SIT DRYER
ON FLEXIBLE
EXHAUST
DO NOT
CRUSH
FLEXIBLE
EXHAUST
AGAINST
WALL
LEVELING AND STABILIZING YOUR DRYER
8
legs, at the corners, to ensure that the dryer is level from side to side
and front to rear.
4 LEVELING LEGS
WARNING
dryer.

ALCOVE OR CLOSET INSTALLATION

9
be stated on a label on the dryer back.
MUST be vented to the outdoors. See the EXHAUST
INFORMATION
other surfaces is: 0 in. either side, 3 in. front, 3 in. rear.
installation and service.
ceiling, etc. is 52 in.
(387 square cm), located 3 in. (7.6 cm) from top and bottom of door. If
the closet contains both a washer and a dryer, doors must contain a
minimum of 120 sq. in. of open area equally distributed.
pressure testing at pressures greater than ½ psi (3.5 kPa).
connection, must be installed immediately upstream of the gas
supply connection to the dryer.
8
LEVEL
SIDE-TO-SIDE
LEVEL
FRONT-TO-BACK
OPEN
DOOR 90°