Transport Safety Information; Storage Conditions - ABB EAN823 Operating Instruction

Safety
Fig. 3
1 Electronic unit type
2 Serial no. / NL no. (no. of non-list
version)
1.6

Transport safety information

Check the devices for possible damage that may have occurred during transport. Damages in
transit must be recorded on the transport documents. All claims for damages must be claimed
without delay against the shipper and before the installation.
Ensure that the specified environmental conditions in the Technical Data chapter are complied
with.
1.7

Storage conditions

The units may be stored under moist and aggressive condition for a short time. The equipment
is protected against external corrosive influences. However, direct exposure to rain, snow, etc.,
must be avoided.
The permissible storage and transport temperatures must be observed.
Actuators equipped with an anti-condensation heater are additionally protected by desiccant,
which is placed in the following locations where condensation may be a problem:
Position sensor:
Electronic unit:
The desiccant guarantees sufficient protection for approximately 150 days. It can be
regenerated at a temperature of 90°C (114°F) within 4 h.
Remove the desiccant prior to commissioning the actuator or the electronic unit.
If you intend to store or transport the device for a longer time (> 6 months) we recommend that
you wrap it in plastic foil and add desiccant.
Protect uncovered metallic surfaces with the appropriate long-term corrosion inhibitor.
The permissible long-term storage temperatures must be observed.
8
1
Elektronik / Electronics Type: ...
2 B.Nr./No.
3
t = ..................°C
4
Automation
D-32425 Minden
Hardware name plate on electronic unit cover
NL
Jahr/Year
IP 66
3 Year of manufacture
4 Permissible ambient
temperature/protection class/CE mark
In connection chamber
In electrical connection chamber
OI/PME/LME/EAN823/EBN853/EBN861-EN
CE
M00362