Mounting; Lme620-Ai, Pme120-Ai; Ean823, Ebn853 - ABB EAN823 Operating Instruction

3

Mounting

Important (Notice)
Prior to installation or service activities, the electronic unit and actuator must be disconnected
from the power supply and secured to prevent unintentional startup.
•
•
•
3.1

LME620-AI, PME120-AI

Important (Notice)
For information about the installation of actuators with integrated electronic unit refer to the
operating instructions for linear or part-turn actuators, see 11.1 "Other applicable documents".
3.2

EAN823, EBN853

1. Fasten module on vertical support with screws of property class 8.8 (tensile strength 800
N/mm
inch).
2. Provide adequate room for installation and make sure the actuator is accessible from all
sides.
3. Cable glands point to the left.
OI/PME/LME/EAN823/EBN853/EBN861-EN
It must also be possible to disconnect the electronic unit and actuator onsite.
All signal and motor cables between the actuator and electronic unit must be shielded.
The shielding must be placed on both housings when connecting the electronic unit and
the actuator.
2
(116032 pounds/square inch), yield strength 640 N/mm
Mounting
2
(92826 pounds/square
17