English
Installing/Replacing the Ribbon Cartridges
For Front Slip Printing
Follow the steps below to install/replace the ribbon cartridge for front slip printing (ERC-32).
1. Turn on the product. (U
2. Open the front cover. (U
3. Remove the used ribbon cartridge if there is one.
4. Turn the knob on the ribbon cartridge a little in the direction of the arrow marked on the
cartridge to remove any slack in the ribbon.
!
CAUTION:
Make sure to note the direction of the arrow marked on the ribbon cartridge when turning the knob.
If it is turned in the reverse direction, the cartridge may be damaged.
5. Insert a new ribbon cartridge until it clicks into place.
6. Turn the knob on the cartridge in the marked direction again to remove any slack in the ribbon.
7. Close the front cover.
"Turning Power On/Off" on page 13
"Opening the front cover" on page 15
)
)
16