Cisco uBR924 Configuration Manual page 36

cable-modem voip best-effort
cable-modem voip best-effort
To allow voice calls to be sent upstream over the cable interface via best effort, use the cable-modem
voip best-effort command from interface configuration mode. To disable best-effort voice calls, use
the no form of this command.
cable-modem voip best-effort
no cable-modem voip best-effort
Syntax Description
This command has no arguments or keywords.
Defaults
Enabled.
Command Modes
Interface configuration
Command History
Release
12.0(5)T
Usage Guidelines
This command allows you to configure the voice traffic on a Cisco uBR924 to allow only calls
having a high priority service identifier (SID) to be connected.
If the dynamic configuration of high priority queues for voice traffic fails, or if the far end cannot
support the multiple SIDs and multiple classes of service required by high priority traffic, the flag
set by this command will be checked. If enabled (the default setting), the call will be allowed to go
through. If disabled, the call will fail.
Examples
The following example shows how to disable best-effort voice calls on a Cisco uBR924 cable
interface, starting from global configuration mode:
uBR924(config)# interface cable-modem 0
uBR924(config-if)# no cable-modem voip best-effort
uBR924(config-if)#
36 Cisco IOS Release 12.0(5)T
Modification
This command was first introduced.