How To Stop Your Pressure Washer; How To Use Accessory Tray - Snapper 20231 Owner's Manual

9. Engage trigger lock to spray gun trigger (Figure 13).
Figure 13 — Spray Gun with Trigger Lock Engaged
10. Move variable pressure control lever to "High"
position, shown on engine as a rabbit (Figure 14).
Figure 14 - Variable Pressure Control Lever
10. Start engine according to instructions given in engine
owner's manual. Also see operating instructions tag
located on the pressure washer.
WARNING
Rapid retraction of starter cord (kickback) will
pull hand and arm toward engine faster than
you can let go.
Broken bones, fractures, bruises or sprains could
result.
• When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
• If engine starts and fails to continue to run or if increased
resistance is felt during starting pull attempts, squeeze trigger
on spray gun.
WARNING
Running engines produce heat.Temperature of
muffler and nearby areas can reach or exceed
150°F (65°C).
Severe burns can occur on contact.
Combustible debris, such as leaves, grass, brush,
etc. can catch fire.
• DO NOT touch hot surfaces.
• Allow equipment to cool before touching.
• The pressure washer must be at least 5 feet from structures
having combustible walls and/or other combustible materials.
• Keep at least 3 feet of clearance on all sides of pressure
washer for adequate cooling, maintenance and servicing.
• In the State of California a spark arrester is required by law
(Section 4442 of the California Public Resources Code). Other
states may have similar laws. Federal laws apply on federal
lands. If you equip the muffler with a spark arrester, it must be
maintained in effective working order.
3000 PSI Pressure Washer

How to Stop Your Pressure Washer

1.
2.
Trigger Lock
3.
NOTE: A small amount of water will squirt out when
pressure is released.
• Keep high pressure hose connected to pump and spray gun
• Squeeze trigger on spray gun to relieve trapped pressure,
4.

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your nozzle extension , and slots to hold the cleaning
solution bottle and the detergent siphoning filter.There are
also two hooks at the ends of the handle to hold your
spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand.The brush and turbo wand are NOT
included with your pressure washer.You can buy these
items as optional accessories.
1.
2.
10
Let engine idle for two minutes.
Turn engine off according to instructions given in
engine owner's manual.
Squeeze trigger on spray gun to relieve trapped
pressure in hose to avoid injury.
WARNING
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun retains high pressure when pressure
washer is shut down, which can cause injury.
while system is pressurized.
every time you stop engine. Engage trigger lock on spray gun.
Engage trigger lock on spray gun when not in use.
Place nozzle extension through hole on accessory tray,
as shown in Figure 15.
Figure 15 — Typical Accessory Tray
Hang chemical solution bottle on "J" hook and place
detergent siphoning filter in last slot on left (Figure 15).