Table of Contents
Advertisement
STEP9: Installbeltguardbetween pulleyguard
andbeltguardsupport c lipon frontpartof blower
mount.Securewith two 5/16 nylon wing nuts.
Tighten nutssecurely.
WEIGHT
KIT INSTALLATION
!! Warning:
Weight kit must be installed prior to
installing
bagger unit.
Failure to do so may
result in Iongitudal tipping of unit.
STEP
10: Insert the four
narrow
weight
bars
through opening in side of foot rest. Be sure holes
in weights are all aligned. Next, insert the two 1/2-
13 x 5 bolts through the five wide weight bars, and
lay the wide bars against front of footrest, inserting
bolts through holes in narrow bars. Secure with
1/2" split lock washers and nuts. Tighten securely.
I
BAGGER
KIT INSTALLATION
STEP 11: Install bumper mount standoffs onto rear
bumper of machine, utilizing existing hardware on
machine. NOTE: Invert hardware when installing
standoffs, installing bolts out through bumper with
nuts facing out.
NOTE: When installing standoffs, be sure that the
bumper
mount plate mounting
holes along the
back bar of the standoffs are located towards the
right side of the machine.
Refer to the Parts List
section of the manual.
STEP 12: Install bumper mount plate onto stand-
offs with four 5/16-18 x 3/4 hex cap screws, secur-
ing with four 5/16-18 flange lock nuts.
Tighten
securely.
Also, install muffler deflector (see inset) onto muf-
fler, making sure deflector directs exhaust off to the
side
of
the
mower.
Fasten
with
clamp.
IMPORTANT:
FAILURE TO INSTALL MUFFLER
DEFLECTOR MAY RESULT IN A FIRE.
7
Advertisement
Table of Contents
