Sharp CD-CH1500H Operation Manual page 91

„ Removing the transport screw
Before turning the power on, be sure to remove the transport screw on the
back of the unit using a flat-blade screwdriver or a coin.
This screw is required when transporting the unit again. Please keep it (see page 37).
„ Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and position the FM aerial
wire in the direction where the strongest signal can be received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM LOOP socket. Position the AM loop aerial for
optimum reception. Place the AM loop aerial on a shelf, etc., or attach it to a stand or
a wall with screws (not supplied).
Notes:
z Placing the aerial on the stereo system or near the AC power lead may cause
noise pickup. Place the aerial away from the stereo system for better reception.
z Do not connect the attached FM aerial to an external FM aerial. Otherwise, trouble
may occur.
Installing the AM loop aerial:
Assembling Attaching to the wall
External FM aerial:
Use an external FM aerial if you require better reception. Consult your dealer.
„ Speaker connection
Main terminals:
Connect the blue wire to the (+) and the black one to the (-).
Subwoofer terminals:
Connect the red wire to the (+) and the black one to the (-).
Caution:
z Connect the speaker wires to the speakers first, then to the unit.
z Never mistake the MAIN and the SUBWOOFER terminals. The stereo system or
the speakers may be damaged.
z Only the included speakers should be used with this product. Do not use other
speakers with this unit or use the supplied speakers with other units.
z Do not mistake the right channel for the left channel when connecting the speakers
to the unit. The right speaker is the one on the right side when you are facing the
front of the unit.
z Do not let the bare speaker wires touch each other.
Wall Screws
z Do not stand or sit on the speakers. You may be injured.
External FM aerial
„ Connecting the AC power lead
After checking all the connections have been made correctly, plug the AC power lead of this
unit into the AC socket. If you plug in the unit first, the unit will enter the demonstration
mode.
Note:
Unplug the unit if it will not be used for a prolonged period of time.
Right speaker
1
Blue Black Red
Incorrect
Demonstration mode (See page 11.)
01/1/9 E1.fm
Left speaker
2 3
Incorrect
ENGLISH E-9