Work After Making Checks/Adjustments - Canon Finisher-R1 Service Manual

1) Check to see that the difference in height between
the finisher and the host machine and the tilt are as
indicated once again. Otherwise, start over the
foregoing steps.
2) When done, tighten the 2 fixing screws [1] each on
the casters.
3) To prevent loosening of the adjusting bolts after
installation (as by relocation), turn each adjusting bolt
[2] about 90 deg in the direction of the arrow. Do not
turn them more than 90 deg; excess tightening can
displace positions.
[1]
F-3-36
4) Fit the pliers in place to the back of the front cover
using a screw.
5) End the installation work by referring to the
instructions in "Work After Making Checks/
Adjustments."
3.2.3.2 Work After Making
Checks/Adjustments
<Finisher-R1>
1) If you removed the auxiliary ring, attach the left
rear foot cover; then, adjust the auxiliary rail to suit
needs of the user, and mount it in place using 4 screws.
2) Mount the front cover to the finisher using 3
screws.
3) Mount the rear upper cover (small) to the finisher
[2]
90
0003-1770
using a screw.
4) Mount the front foot cover [1] using a screw [2] (RS
tightening ; M3x8).
[2]
[1]
F-3-37
5) Connect the finisher ant the host machine using the
interface cable[1].
6) Fix the cable clamp [2] to the host machine, and
route the interface cable [1] through it.
When connecting the interface cable, be sure to
turn off the host machine and disconnect its power
plug from the power outlet before starting the work.
Otherwise, you may suffer an electric shock.
Chapter 3
3-15