Sony ODS-L30M Operation Manual page 58

11
Press the j button.
The following screen appears.
12
Press the ENTER button.
The first digit of the IP address blinks, indicating that
it can be changed.
13
Enter the IP address.
Use the K and k buttons to move the cursor, and use
the J and j buttons to change the values.
14
Press the ENTER button after entering the address to
confirm it.
15
Press the j button to display [IPv4 Netmask], and
configure the subnet mask using the same method as
the IP address.
16
Press the j button to display [IPv4 Gateway], and
configure the default gateway using the same method.
17
Press the j button.
[IPv4 DNS] appears.
18
To configure the DNS address, select [Static].
If the current setting is [Auto], display the selection
screen using the ENTER button, use the J and j
buttons to select [Static], and then press the ENTER
button to confirm.
58
Configuring the Network
Note
To obtain the DNS address automatically, select
[Auto]. Confirm the setting using the same method as
you would with [Static], and proceed to step 24.
19
Press the ENTER button.
The [IPv4 Primary DNS] screen appears.
20
Press the ENTER button.
The first digit of the IP address blinks, indicating that
it can be changed.
21
Use the K, k, J, and j buttons to enter the primary
DNS address, and press the ENTER button.
22
Press the j button.
The [IPv4 Secondary DNS] screen appears.
23
Enter the secondary DNS address using the same
method as step 20, and press the ENTER button.
24
Press the j button.
The following confirmation screen appears.
25
Check that [Save] is selected, and press the ENTER
button.
The changed IP address is enabled.
The [Network1] screen appears again.
26
Press the BACK button three times to end menu
operation.
IP addresses can also be changed in the Web screen
(Library Maintenance Web UI).
For details on changes using the Library Maintenance
Web UI, refer to the Library Maintenance Web UI
Help.