Starting & Stopping Wheel Drive; Starting & Stopping Mower Blades - Snapper LT180H42IBV, LT200H42IBV2, LT200H48IBV2 Safety Instructions & Operator's Manual

Section 2 - OPERATING INSTRUCTIONS
2.3 STARTING & OPERATION (Continued)
2.3.2. STARTING WHEEL DRIVE
1. Shift speed control lever to neutral.
2. Start engine. Refer to Section "STARTING
ENGINE".
3. Release clutch/brake pedal.
4. Slowly shift speed control lever forward for
forward motion or to the rear for reverse motion. See
Figure 2.7.
SPEED CONTROL LEVER
FORWARD
SPEEDS
2.3.3 STARTING MOWER BLADE
1. Start engine. Refer to Section "STARTING
ENGINE".
2. Pull blade switch OUT to engage blade. See
Figure 2.8.
PUSH BLADE SWITCH IN TO
THE "OFF" POSITION
OFF
WARNING
DO NOT operate blades with machine in reverse.
STOP BLADES. LOOK and SEE behind and down
for children, pets and hazards before and while
backing.
NEUTRAL
REVERSE
FIGURE 2.7
ON
PULL BLADE
SWITCH OUT TO
THE "ON"
POSITION
FIGURE 2.8
2.4 STOPPING ENGINE, BLADE, WHEEL DRIVE
2.4.1. STOPPING ENGINE
1. Stop engine by turning key to the "OFF"
position. See Figure 2.9.
OFF
2.4.2. STOPPING WHEEL DRIVE
1. Fully depress clutch/brake pedal to stop wheel
drive. See Figure 2.10.
CLUTCH/BRAKE
PEDAL
9
RUN
START
KEY
FIGURE 2.9
FULLY DEPRESS
CLUTCH/BRAKE PEDAL TO
STOP WHEEL MOTION
FIGURE 2.10