Electrical Requirements; Drain Kit - GE RAB77B Installation Instructions Manual

ELECTRICAL REQUIREMENTS

Provisions should be made to have the proper
electrical outlet near the case. All wiring should
be made in accordance with local codes and
regulations. The line cord included with the chassis
(if used) will extend to a wall receptacle located
within the area shown in tabulation below.
"A"
Inside
Model
Wall Receptacles
230V/208V 15 amp 230V/208V 20 amp
"tandem" type "perpendicular" type
All wiring should be made in accordance with local
electrical codes and regulations.
See the Owner's Manual for how to connect
electrical supply.
NOTE:
Aluminum wiring in structure may pose special
problems—consult a qualified electrician.
"B"
"A" "B"
230V 30 amp
"tandem" type
Specifications subject to change without notice
A Quality Product of GE Appliances

DRAIN KIT

If it is necessary to install a drain kit on this wall
case, the following kit is available:
RAD10 Internal/External Drain
1. With an "Internal Drain", the condensate drain
tube must be connected to an internal drain
system in the building.
WALL CASE WITH RAD10 DRAIN UNIT
Note: Shaded parts
included with
RAD10 drain kit
Steel mounting plate
Type "B" screws
2. With an "External Drain" (which may be
connected to a field-supplied drain line),
condensate water can be drained away from the
unit and building.
WALL CASE WITH RAD10 DRAIN UNIT
Note: Shaded parts
included with
RAD10 drain kit
Neoprene sponge gasket
Steel mounting plate
Type "B" screws
NOTE:
It may be desirable or necessary to install the drain
kit on the case prior to installing the case into
the wall.
SCREW
Type "A"
METAL
4
INTERNAL DRAIN
See detail
below
Overflow relief drain
Square drain holes
Neoprene sponge gasket
Gasket
Speed nuts
Cabinet bottom
Tube
1/2" O.D.
Cover plate
Type "A" screws
EXTERNAL DRAIN
Overflow relief drains
Square drain holes
1/2" O.D. drain tube
SCREW
Type "B"
PLASTIC
Alternate
6" long, 1/2"
O.D. straight
copper tube.